Panasonic S-160PE1R5B Technical Data & Service Manual page 253

2. Wireless Remote Controller
RECEIVER
1. Receiver Receives the signal sent from the
remote controller.
2. Emergency Display lamps
operation button
When an error occurs, one of the
lamps flashes. When a display
lamp is blinking, refer to " Before
Requesting Service ".
3. Operating lamp This lamp is lit when the unit is
operating.
4. Timer lamp This lamp is lit when the timer is set.
5. Standby lamp
6. Filter lamp This lamp is for notifying you when
the filter needs to be cleaned.
NOTE
If a heat pump model is being used, it will beep twice and the operating lamp will light up on the display; if the timer and standby
lamps blink alternately, a conflict between the heating and cooling exists, so the unit cannot operate in the desired mode.
(On models that do not have an Auto function, even if Auto is selected, it works in the same way.)
When the local operation is disabled by such as the centralized control, and if the Start, Stop, Mode or Temperature setting
buttons are pressed, the unit will beep five times and the change will not be made.
When the heater is working, the
lamp lights at the following times.
When the thermostat has operated
during defrosting at the time of the
startup.
The lamp flashes when an error
occurs.
CZ-RWSC3
1
2
3
4
5
6
Front side
8-17
ADDRESS 1
ADDRESS 2
ADDRESS 3
REM SUB/MAIN
1 2 3 4
Rear side
8