Panasonic S-160PE1R5B Technical Data & Service Manual page 97

NOTE
Do not wind the armoring tape too tightly since this will decrease
the heat insulation effect. Also ensure that the condensation drain
hose splits away from the bundle and drips clear of the unit and
the tubing.
5. Finishing the Installation
After finishing insulating and taping over the tubing, use sealing
putty to seal off the hole in the wall to prevent rain and draft from
entering. (Fig. 1-11-2-1-25)
Apply putty here
HOW TO INSTALL THE TIMER REMOTE
CONTROLLER OR HIGH-SPEC WIRED
REMOTE CONTROLLER (OPTIONAL PART)
NOTE
See "Section 2. TEST RUN".
Indoor Fan Performance
Type E1
S-160PE1R5B P-Q curve
150
100
L
50
0
20.0 30.0 40.0
Air Volume (m
Tubing
Fig.1-11-2-1-25
H
M
50.0 60.0 70.0
3
/min)
1-11-2-1-8
Accessories Supplied with Unit
Table 1-11-2-1-1 (Ducted)
Part Name Figure
Washer
Flare
insulator
Insulating
tape
Hose band
Foam drain
socket
Drain hose
Use M10 for suspension bolts.
Suspension bolts and nuts are fi eld supply.
Type of Copper Tube and Insulation Material
If you wish to purchase these materials separately from a local
source, you will need:
1.
Deoxidized annealed copper tube for refrigerant tubing.
2. Foamed polyethylene insulation for copper tubes as required
to precise length of tubing. Wall thickness of the insulation
should be not less than 8 mm.
3.
Use insulated copper wire for fi eld wiring. Wire size varies
with the total length of wiring. See "1-10. ELECTRICAL
WIRING" for details.
CAUTION
Check local electrical codes and regulations before
obtaining wire. Also, check any specified instructions or
limitations.
Additional Materials Required for Installation
1.
Refrigeration (armored) tape
2. Insulated staples or clamps for connecting wire (See your
local codes.)
3.
Putty
4.
Refrigeration tubing lubricant
5.
Clamps or saddles to secure refrigerant tubing
6. Scale for weighing
Q'ty Remarks
For suspending indoor
8
unit from ceiling
For gas and liquid
2
tubes
For gas and liquid
2
tubes flare nuts
For securing drain
6
hose
For drain hole
1 (another side of drain
hose)
1
1