Before Requesting Service - Panasonic S-160PE1R5B Technical Data & Service Manual

2. Wireless Remote Controller

8-31. Before Requesting Service

Before requesting service, please check the followings.
P o r b e l m
The unit doesn't work even
when is pressed on the
remote controller.
The air conditioner starts and
stops on its own.
" is displayed on the remote
"
controller when the unit is stopped.
Although the unit is for air conditioning only, either Auto or Heat is indicated
in the display.
After putting the batteries in the remote controller, even when it is operated,
the display does not change.
The timer cannot be set.
If the problem persists even after you check the foregoing items, stop the unit, disconnect the power to the indoor unit and
contact the dealer where the product was purchased with the model number and problem you are having.
As it is dangerous, under no circumstances should you undertake repairs yourself.
Further, when the receiver's lamps are blinking; please contact your retailer with that information.
Specifications
CZ-RWSK2
Wireless Remote
Controller
CZ-RWSC3
Dimensions CZ-RWSC3
Receiver
8
The power to the indoor unit is not ON.
Are the remote controller's batteries dead?
Is there a mismatch between the display lamp and
cooling/heating or is it set to something other than
Auto? (The operating lamp stays lit, while the timer
lamp and the standby lamp blink alternately.)
Do the addresses match one another?
Has the timer been set to repeat?
An error has occurred in the non-volatile
memory.
Dimensions 182 mm (H) X 61 mm (W) X 18.5 mm (D)
Power source Two LR03 size batteries
Clock Accuracy ±30 seconds per month (at 25 °C)
120 mm (H) X 70 mm (W) X 20 mm (D)
16 V DC (Supplied from the terminal strip of the
Power source
indoor unit's remote controller)
C a u s e
Make sure the power to the indoor unit is ON.
Change the batteries.
Change the operating mode.
Check the addresses of the receiver and the
remote controller. (See Page 8-22)
Check the timer settings.(See Page 8-20)
Please contact your sales outlet.
Make settings to the remote controller's operation
mode display. (See Page 8-25)
Press the Reset button on the remote controller.
(See Page 8-18)
Make the settings when the remote controller is in
Operation Display. (See Page 8-20)
8-26
Solution