Using The Remote Controller - Panasonic CU-KS18NKU Technical & Service Manual

Temperature Display Selector button
Time Display Selector button
ACL button (ALL CLEAR)
ADDRESS switch
The remote controller sends the temperature signal to the air conditioner regularly at five minute intervals.
NOTE
If the signal from the remote controller stops for more than 15 minutes due to the loss of the remote
controller or other trouble, the air conditioner will switch to the temperature sensor which is built into the
indoor unit and control the room temperature. In these cases, the temperature around the remote
controller may differ from the temperature detected at the air conditioner's position.
How to Install Batteries
ACL button
CAUTION
Information for Users on Collection and Disposal of Old Equipment and used Batteries
[Information on Disposal in other
Countries outside the European Union]
These symbols are only valid in the
European Union. If you wish to discard these
items, please contact your local authorities
or dealer and ask for the correct method of
disposal.
10
REMOTE CONTROLLER (CONTINUED)
This switches the temperature display between °C and °F.
This switches the time display between 24-hour time and 12-hour time.
Puts the remote controller into pre-operation status. Always press this button
after replacing the batteries.
• The address switch changes to prevent mixing of signals from remote
controller's when two air conditioners are installed next to each other.
Normally, the address switch is set to A. For more information, please contact
the dealer where you made the purchase.
• Normally, the tabs on the remote controller should not be bent.

USING THE REMOTE CONTROLLER

• The batteries last about six months, depending on how much you use
the remote controller. Replace the batteries when the remote controller's
display fails to light, or when the remote controller cannot be used to
change the air conditioner's settings.
• Use two fresh leak-proof type-AAA alkaline batteries.
• In replacing batteries, follow the instructions as mentioned in the
subsection "How to Install Batteries".
• If you do not use the remote controller more than 1 month, take out the
batteries.
• Dispose of the used batteries at the designated location in compliance
with the applicable local ordinances.
1. Slide the cover in the direction indicated by the arrow
and remove it.
2. Install two AAA alkaline batteries. Make sure the
batteries point in the direction marked in the battery
compartment.
3. Use a thin object such as the tip of a pen to press the
ACL button.
Note for the battery symbol (bottom two
symbol examples):
This symbol might be used in combination
with a chemical symbol. In this case it
complies with the requirement set by the
Directive for the chemical involved.
Pb