Lock Individual Flap; Operating Multiple In/Outdoor Units Simultaneously (Group Control) - Panasonic S-160PE1R5B Technical Data & Service Manual

8-6. Lock Individual Flap

(Supported models: 4-way ceiling cassette type)
You can set the flap for each air outlet individually according to the room condition.
• Even if the flap setting is changed with
1. Press and
or longer.
• " " starts blinking and the setting screen is displayed.
2. Press /
then press
• Every time you press / to switch between "U1 ↔ U2 ↔ ...
↔ U8 ↔ AL (All indoor units that are connected to the remote
controller)", the buzzer sounds from the corresponding receiver.
• When settable: 1 short beep
• When not settable*: 1 short beep followed by 1 long beep
* When the indoor unit is not connected or does not support
this function.
3. Press /
• Every time you press
↔ F4 ↔ AL (All the air outlets)".
• The square mark (indented ) on the panel of the indoor unit
indicates air outlet No. 1.
There are some models that do not have a square mark
(indented ).
• The air outlet No. changes according to the installation direction.
Check by actual operation.
4. Press /
• Every time you press
(Swing) ↔
5. Press .
• You can return to Step 2 to continue setting if you press
Note
• Press to stop operation in the middle.
CZ-RWSC3
The available functions differ depending on the indoor unit being used.
The wind direction cannot be set via remote controller for any models other than those noted below.
For more information, please refer to the users' manual that came with your indoor unit.
4-Way Cassette Models, Ceiling Models, Wall-Mounted Models
8
Please refer to Setting the Wind Direction and Stopping Flap Swing.

8-7. Operating Multiple In/Outdoor Units Simultaneously (Group Control)

Group control works well for providing air conditioning to 1
large room with more than 1 air conditioning units.
1 remote controller can operate up to 8 indoor units.
All the indoor units have identical settings.
Set temperature sensing to the indoor unit (Main sensor).
(See page 8-3)
at the same time for 4 seconds
to select the indoor unit to set,
.
to select the air outlet.
/ , it cycles from "F1 ↔ F2 ↔ F3
to select the flap direction, then press
/ , it cycles from "
↔ ↔ ↔ ↔ ".
(Page 8-6), the flap directions set here are not changed.
(Unlock) ↔
instead of
Receiver
8-8
Flap Indoor unit
1
3
Square mark (indented )
F1
F2 F4
F3
.
.
Outdoor unit
Indoor unit
Signal line
Infrared remote controller
Air outlet
2, 4
1, 2, 4
5