Finishing The Installation; How To Install The Timer Remote Controller (Optional Part); Note; Refer To The Operating Instructions Attached To The Optional - Panasonic EAIRC-MJ Series Installation Instructions Manual

5-5. Finishing the Installation

After finishing insulating and taping over the tubing, use sealing
putty to seal off the hole in the wall to prevent rain and draft
from entering. (Fig. 5-10)
Apply putty here
6. HOW TO INSTALL THE TIMER
REMOTE CONTROLLER (OPTIONAL
PART)

NOTE

Refer to the Operating Instructions attached to the optional

Timer Remote Control Unit.

System diagram
* Operation manual included in package.
Special service checker wiring
Tubing
Fig.5-10
Outdoor unit maintenance
remote controller
Special service checker wiring
(Servicing No.: CV6231785082)
Remote controller Ass'y
7. HOW TO INSTALL WIRELESS
REMOTE CONTROLLER RECEIVER
NOTE
Refer to the Operating Instructions attached to the optional Wire-
less Remote Controller Receiver.
8. HOW TO PREPARE THE SYSTEM FOR
OPERATION
In order to operate the air curtains properly, following settings
must be made on the outdoor units:
■ ECOi series units
MF2 3-PIPE
ME1 2-PIPE
LE1 2-PIPE
1. After finishing the addressing procedure (refer to the
outdoor unit test run service manual supplied with the
outdoor unit) please connect the standard timer remote
controller (CZ-RTC2) just for the setting purpose to the
outdoor unit as shown in Fig. 8-1:
Outdoor unit
Outdoor unit
control PCB
PCB connector (3P, BLU)
Relay connector (2P, WHT)
Remote controller Ass'y
20
U-8MF2E8, U-10MF2E8, U-12MF2E8,
U-14MF2E8, U-16MF2E8
U-8ME1E81, U-10ME1E81,
U-12ME1E81, U-14ME1E81,
U-16ME1E81, U-18ME1E81,
U-20ME1E81
U-4LE1E5, U-4LE1E8, U-5LE1E5,
U-5LE1E8, U-6LE1E5, U-6LE1E8
Inter-unit control wiring
Indoor
unit
Remote
Controller
Outdoor unit control PCB
RC (3P, BLU)
Indoor
unit
Remote
Controller
Fig.8-1