Janome JR3000 Series Operation Manual page 3

Attention
Attention
Attention
Warning
Warning
Warning
Note: The operation methods described in this manual are indicated as follows:
Operation via the teaching pendant
TP
Operation via PC (JR C-Points II)
PC
Specifications
To make full use of the machine's functions and capabilities, make sure that
you use the robot according to the correct handling/operation procedures
that are written in the manuals listed on the previous page.
If you turn OFF the power after making changes to robot's settings or data
without saving, these changes are lost and the robot will revert to its original
settings. Make sure that you save any changes to data and/or settings.
Before using this robot for the first time, make sure you back up robot data
and save the individual configuration information. Individual configuration
information is needed when replacing internal circuit boards.
Always make sure the machine is grounded through the power
cord. Do not use the machine when it is not grounded.
Improper grounding causes electric shocks, fires, malfunction, and
unit breakdown.
Make sure that the machine power supply is OFF before
connecting the power cord.
Failure to do so could cause electric shock and/or injury.
Do not handle or operate the robot in ways not covered in the
manuals listed on the previous page. Contact Janome (listed on the
back page of this manual) for repairs.
Failure to do so can cause electric shock and/or injury.
2 Desktop Robot JR3000