Husqvarna Automower 305 Technical Manual page 81

A1
Guide1
A2
If the LED is flashing yellow in test b) then
the break is somewhere in the boundary
wire between A2 and the position where the
guide wire is connected to the boundary
wire (thick black line in the illustration
below).
A1
Guide1
A2
5. Put all connections back in their original
positions. Then disconnect A2. Connect
a new loop wire to A2 Connect the other
end of this new loop wire somewhere in
the middle of the installation. If the LED
turns green then the break is somewhere
in the stretch between the disconnected
end and the position where the new cable
has been connected (thick black line in the
illustration below). If that is the case, move
the connection for the new cable closer to
the disconnected end (approximately in the
middle of the suspected stretch) and check
again whether the LED has turned green.
Continue until there is only a very short
stretch that makes the difference between a
blue flashing and a green continuous light.
6� TROUBLE SHOOTING
3020-061
3020-062
A1
A2
A1
A2
A1
A2
6. When the break has been found, the
damaged part should be replaced with a
new cable. If it is possible to shorten the
boundary wire, the damaged part can be
cut away. Only use original Husqvarna
connectors.
3020-063
3020-064
3020-065
3012-832
English - 79