Show Monitors As Bar Graphs - YASKAWA GA800 Series Technical Reference

4.6 Keypad Operation
6.
Push .
7.
Push or
Enter the three digits in "x-xx" part of monitor Ux-xx to identify which monitor to output. For example, to show
monitor U1-01 [Frequency Reference], set it to "101" as shown in this figure.
The configuration procedure is complete.
◆

Show Monitors as Bar Graphs

The procedure in this section shows how to show a specific monitor as a bar graph. You can show a maximum of
three.
1.
Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If the screen does not show [Home] for
2.
Push (Menu).
3.
Push or
4.
Push or
156
to select the monitor number to register, then push
, push
to select [Monitors], then push
to select [Display Bar Graph], then push
.
(Back), and then push
.
.
YASKAWA SIEPC71061737B GA800 Drive Technical Reference
to show [Home].