AT&T SYSTEM 25 Manual page 188

Making a Data Call from the STARLAN NETWORK to System 25
The following procedure assumes the PC originating the data call is:
Connected to the STARLAN NETWORK
Running the STARLAN NETWORK client software
Loaded with NAUCOM
Running the CAM or 4410 Terminal Emulator software
Be sure the communications port on the terminal emulator is set for STARLAN
NOTE:
NETWORK. For example, the
Options screen should be set to
1
Load NAUCOM and the terminal emulator the PC.
The following prompt is displayed:
2
Type
The following message is displayed:
The Command Mode menu is displayed.
NOTE:
3
Select
4 At the
5
The call is connected.
Ending a STARLAN NETWORK Data Call
The option in the Command Mode menu is used to end a connection to the
<Hangup>
data port. This option is needed for STARLAN NETWORK endpoints to disconnect from
a STARLAN Interface Circuit Pack (CP).
1 Select
2
To hang up, select
or
To return to the top level of Command Mode without
hanging up, select
4-14 Data Terminal Features
Communications port
In addition, parity must be set to "none".
STARLAN .
Remote host name
and press
attpbx [ R E T U R N ]
connecting to attpbx. . . , SUCCESS
If necessary, the flow control can be changed by typing
<Data call> .
prompt, enter the data endpoint DDC and press
DIAL:
<Hangup> .
.
<All>
.
<eXit>
option on the 4410 Terminal Emulator
.
[Ctrl] [x] .
[RETURN].