Kenwood TK-2170 Series Function Reference page 57

15.1.2 Scan Weight
Scan Weight can be used to configure the duration to
decode the LTR ID sent from the repeater during the
scan.
The transceiver uses the LTR ID provided by the repeater
to unmute and Trunkout. If there are several Group IDs
having the same Home number in the LTR Trunked
Radio System, other users having the same Home
number must Trunkout. Therefore, it may take a long
time for a user to receive their own LTR ID.
In this case, Scan Weight must be configured longer so
as not to miss LTR Data during the scan.
1 weight is approximately 500 ms long.
Scan Weight can be configured by using KPG-101D.
Configuration using KPG-101D
• Configuring the Scan Weight (Refer to FPRG
6.3.2 Scan Weight.)
15.1.3 Wide/ Narrow
Select the desired Channel Spacing for the available LTR
Trunked Radio System.
Wide/ Narrow can be configured by using KPG-101D.
Configuration using KPG-101D
•
Configuring the Wide/ Narrow (Refer to FPRG
6.3.3 Wide/ Narrow.)
15.1.4 Data Zone-GID
Data Zone-GID can be used to separate the GIDs for
data communications from the GIDs for voice
communications. (Refer to 23.1.2 Data Zone-CH/GID on
page 120.)
Data Zone-GID can be configured by using KPG-101D.
Configuration using KPG-101D
•
Configuring the Data Zone-GID (Refer to FPRG
6.3.4 Data Zone-GID.)
FUNC (K)/Ver. 1.01
15.1.5 Data Delay Time
The Data Delay Time is the duration from when the
transceiver starts transmitting to when the transceiver
starts sending LTR Data. This delay time can be used
when the transceiver cannot establish a link to the
repeater.
The Data Delay Time can be configured by using KPG-
101D.
Configuration using KPG-101D
•
Configuring the Data Delay Time (Refer to FPRG
6.3.5 Data Delay Time.)
15.1.6 Home GID
Home GID can be used to jump to a frequently used GID
with a press of a key.
page 10.)
Home GID can be configured by using KPG-101D.
Configuration using KPG-101D
•
Configuring the Home GID (Refer to FPRG 6.3.6
Home GID.)
•
Assigning functions to the PF keys (Refer to
FPRG 6.8 Key Assignment.)
15.1.7 Operator Selectable
Home-GID
Operator Selectable Home-GID can be used to configure
the Home GID. A user can change the Home GID by
selecting the GID to be configured as the Home GID and
pressing and holding the Home CH/GID key for 3
seconds while this function is enabled.
Operator Selectable Home-GID can be configured to be
enabled or disabled by using KPG-101D.
Configuration using KPG-101D
•
Configuring the Operator Selectable Home-GID
(Refer to FPRG 6.3.7 Operator Selectable Home-
GID.)
Confidential
15 LTR TRUNKING
(Refer to 2.7 Home CH/GID on
Contents Index
45