Table 169 Wireless Features - ZyXEL Communications P-2602H User Manual

Appendix A Product Specifications
Table 168 Voice Features
SIP ALG
Other Voice
Features
Wireless Features (Wireless Devices Only)

Table 169 Wireless Features

IEEE 802.11g+ Wireless LAN
External Antenna
Wireless LAN MAC Address
Filtering
WEP Encryption
Wi-Fi Protected Access
WPA2
378
Your device is a SIP Application Layer Gateway (ALG). It allows VoIP calls to
pass through NAT for devices behind it (such as a SIP-based VoIP software
application on a computer).
SIP version 2 (Session Initiating Protocol RFC 3261)
SDP (Session Description Protocol RFC 2327)
RTP (RFC 1889)
RTCP (RFC 1890)
Voice codecs (coder/decoders) G.711, G.726, G.729
Fax and data modem discrimination
DTMF Detection and Generation
DTMF: In-band and Out-band traffic (RFC 2833),(PCM), (SIP INFO)
Point-to-point call establishment between two IADs
Quick dialing through predefined phone book, which maps the phone dialing
number and destination URL.
Flexible Dial Plan (RFC3525 section 7.1.14)
Your device supports IEEE 802.11g+ to allow any ZyXEL WLAN
devices that also support IEEE 802.1g+ to associate with the ZyXEL
Device at higher transmission speeds than with standard IEEE
802.11g.
The ZyXEL Device is equipped with an attached antenna to provide a
clear radio signal between the wireless stations and the access
points.
Your device can check the MAC addresses of wireless stations
against a list of allowed or denied MAC addresses.
WEP (Wired Equivalent Privacy) encrypts data frames before
transmitting over the wireless network to help keep network
communications private.
Wi-Fi Protected Access (WPA) is a subset of the IEEE 802.11i
security standard. Key differences between WPA and WEP are user
authentication and improved data encryption.
WPA 2 is a wireless security standard that defines stronger
encryption, authentication and key management than WPA.
P-2602H(W)(L)-DxA User's Guide