Bandwidth Management Rule Setup; Figure 171 Bandwidth Management: Rule Setup; Table 121 Bandwidth Management: General; Table 122 Bandwidth Management: Rule Setup - ZyXEL Communications P-2602H User Manual

Chapter 21 Bandwidth Management
The following table describes the labels in this screen.

Table 121 Bandwidth Management: General

LABEL
Active
Auto
Classifier
Apply
Cancel

21.7 Bandwidth Management Rule Setup

You must use the Bandwidth Management General screen to enable bandwidth
management before you can configure rules.
Click Advanced > Bandwidth MGMT > Rule Setup to open the following screen.

Figure 171 Bandwidth Management: Rule Setup

The following table describes the labels in this screen.

Table 122 Bandwidth Management: Rule Setup

LABEL
Direction
Service
Priority
294
DESCRIPTION
Select the check box to enable bandwidth management.
Select the check box to enable Automatic Traffic Classifier (ATC). ATC assigns each
packet to a bandwidth management class based on its size, since time-sensitive
applications such as VoIP tend to have smaller packet sizes than non-time sensitive
applications such as FTP. When ATC is enabled, traffic with a smaller packet size is
assigned a higher priority than traffic with a larger packet size.
Click Apply to save your settings back to the ZyXEL Device.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Select LAN to apply bandwidth management to traffic that the ZyXEL Device
forwards to the LAN.
Select WAN to apply bandwidth management to traffic that the ZyXEL Device
forwards to the WAN.
Select WLAN to apply bandwidth management to traffic that the ZyXEL Device
forwards to the WLAN.
Select a service for your rule or you can select User define to go to the screen
where you can define your own.
Select a priority from the drop down list box. Choose High, Mid or Low.
P-2602H(W)(L)-DxA User's Guide