Static Route Edit; Figure 167 Static Route; Table 115 Static Route - ZyXEL Communications P-2602H User Manual

Chapter 20 Static Route

Figure 167 Static Route

The following table describes the labels in this screen.

Table 115 Static Route

LABEL
#
Active
Name
Destination
Netmask
Gateway
Modify
Apply
Cancel

20.2.1 Static Route Edit

Select a static route index number and click Edit. The screen shown next appears. Use this
screen to configure the required information for a static route.
288
DESCRIPTION
This is the number of an individual static route.
This field shows whether this static route is active (Yes) or not (No).
This is the name that describes or identifies this route.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
This parameter specifies the IP network subnet mask of the final destination.
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward
packets to their destinations.
Click the edit icon to go to the screen where you can set up a static route on the
ZyXEL Device.
Click the delete icon to remove a static route from the ZyXEL Device. A window
displays asking you to confirm that you want to delete the route.
Click this to apply your changes to the ZyXEL Device.
Click this to return to the previously saved configuration.
P-2602H(W)(L)-DxA User's Guide