Side Panel - Zoom MRS-1044 Operation Manual

which a mic or line-level device can be connected.
• GUITAR/BASS: This is a phone jack to which a passive-
type electric guitar or bass can be connected directly.
N
OTE
These jacks are given priority in the order of GUITAR/BASS
→ UNBALANCE → BALANCE. For example, if all three are
connected, the GUITAR/BASS jack will be selected.
(2) [INPUT 2] jacks
These are the input jacks for INPUT 2. When connecting a
stereo output device, use these jacks in conjunction with
the [INPUT 1] jacks. Select and use one of the following
two jacks.
• BALANCE: This is an XLR balanced jack to which a mic
or line-level device can be connected.
• UNBALANCE: This is an unbalanced phone jack to
which a mic or line-level device can be connected.
N
OTE
If both jacks are connected, the UNBALANCE jack will be
selected.
(3) [OUTPUT] jacks
These jacks output the signal that has passed through the
MASTER fader. The following three jacks can be used
simultaneously.
• MASTER: These are RCA phono analog output jacks.
• PHONES: A pair of stereo headphones can be connected
to this jack. Use the knob beside this jack to adjust the
headphone volume.
• DIGITAL: This is an optical-type digital output jack.

Side panel

ZOOM MRS-1044
This slot is for installation of a separately sold SCSI board or USB board (planned for release).
(4) [EXP PEDAL] jack
A separately sold expression pedal (ZOOM FP01, FP02)
can be connected to this jack.
(5) [FOOT SW] jack
A separately sold foot switch (ZOOM FS01) can be
connected to this jack.
(6) [MIDI IN] connector
MIDI messages can be input from this connector.
(7) [MIDI OUT] connector
MIDI messages can be output from this connector.
(8) [PHANTOM ON/OFF] switch
When this switch is on, +48V phantom power will be
supplied to the two [INPUT 1/2] BALANCE jacks.
N
OTE
If devices that do not require phantom power are
connected to the [INPUT 1/2] BALANCE jacks, you must
turn this switch off.
(9) [POWER] switch
This switch turns the power of the MRS-1044 on/off.
N
OTE
When turning off the power of the MRS-1044, you must use
the [POWER] switch. If you turn the power off by simply
disconnecting the AC adaptor plug, the previously recorded
content or changes will be lost.
(10)[DC 12V] jack
Connect the included AC adaptor to this jack.
Rear panel
13