Basic Operation Of The Track Mixer; Adjusting The Volume/Pan/Eq - Zoom MRS-1044 Operation Manual

2.
Press the INPUT 1 (or INPUT 2) [ON/OFF] key.
The input mixer will be selected for pan adjustments.
3.
Turn the dial to edit the value of the PAN parameter.
The PAN parameter can be adjusted in a range of L100 (far
left) – 0 (center) – R100 (far right).
4.
When you have finished adjusting the pan, press
the [EXIT] key.
You will return to the main screen.
The function of the PAN parameter will change as follows,
depending on the number of input jacks that are currently
turned on, and on the number of recording tracks that are
currently selected.
• When no recording track is selected
For the signal that is sent from the input mixer to the L/R
channels of the [OUTPUT] jacks, the PAN parameter will
adjust the pan (if either but not both INPUT 1 or 2 are
enabled) or the balance (if both INPUT 1 and 2 are
enabled).
• When two mono tracks or a stereo track is
selected as the recording track
For the signal that is sent from the input mixer to the pair
of odd-numbered/even-numbered tracks, the PAN
parameter will adjust the pan (if either but not both INPUT
1 and 2 are enabled) or the balance (if both INPUT 1 and 2
are enabled).
• When one mono track is selected as the
recording track
The PAN parameter will have no effect.
ZOOM MRS-1044

Basic operation of the track mixer

Basic operation of the track
mixer

Adjusting the volume/pan/EQ

For each channel, you can adjust the volume, pan (stereo
position between the L/R channels of the [OUTPUT] jack),
and EQ (equalizer).
1.
To adjust the volume (output level) of a channel,
operate the fader of the corresponding channel
(DRUM, BASS, 1 – 6, 7/8, 9/10).
H
INT
• To check the precise setting of the volume (FADER
parameter), press the following sequence of keys:
TRACK PARAMETER section [PAN] key → cursor [
→ status key of the desired channel.
• You can check the MASTER fader setting by pressing
any TRACK PARAMETER key → MASTER status key.
2.
To adjust the pan of a channel, press the TRACK
PARAMETER section [PAN] key, and then press one
of the status keys (DRUM, BASS, 1 – 6, 7/8, 9/10) to
select the desired channel.
A screen will appear in which you can adjust the PAN
parameter of the selected channel.
3.
Turn the dial to adjust the value of the PAN
parameter.
The range is L100 (far left) – 0 (center) – R100 (far right).
If you want to continue and adjust the pan of another
channel, repeat steps 2 – 3.
H
INT
• For channels 7/8, 9/10, and DRUM, the PAN parameter is
used to adjust the balance (the volume balance of the left
and right channels).
• In the parameter screen you can also use the cursor
Q W
[ ]/[ ] keys to select parameters, and the cursor
E R
[ ]/[ ] keys to switch channels.
4.
To adjust the EQ, press the [EQ HIGH] key or [EQ
LOW] key.
Press the [EQ HIGH] key to adjust the high-range tone, or
the [EQ LOW] key to adjust the low-range tone.
W
] key
49