General; Introduction; Installation - Vulcan-Hart CBFT Series Installation & Operation Manual

F-47102 (06-14) CBFT SERIES
Vulcan Heated Holding Cabinets are
produced with quality workmanship and
material. Proper installation, usage, and
maintenance of your cabinet will result
in many years
performance.
Before installing, verify that the electrical
service agrees with the specifications on
the rating plate located on the lower
back corner of the cabinet. (Fig.1) If the
supply and equipment requirements do
not agree, do
unpacking and installation.
your Vulcan
Department immediately.
UNPACKING:
The Cabinet was inspected before
leaving the factory. The transportation
company assumes full responsibility for
safe delivery upon acceptance of the
shipment. Immediately after unpacking,
check for possible shipping damage to
the cabinet.
If the cabinet is found to be damaged,
save the packaging material and
contact the carrier within 15 days of
delivery.
Carefully unpack and place in a work
accessible area as near the installation
position as possible.

GENERAL

INTRODUCTION

of satisfactory

INSTALLATION

not proceed with
Contact
Customer Service
It is suggested that you thoroughly read
this entire manual and carefully follow all
of the instructions provided.
The CBFT
Cabinets are
designed for
operations.
1. Open the door and carefully
remove any packaging materials.
2. Peel off vinyl protection film.
CLEANING:
The cabinet should be thoroughly
cleaned prior to putting into service.
Use a mild soap and water solution to
clean the interior of the unit. Never use
harsh chemicals or abrasive pads to
clean the unit.
instructions in this manual.
LOCATION:
For efficient cabinet operation, choose a
location that will provide easy loading
and unloading without interfering with
the final assembly of food orders.
The installation location must allow
adequate clearances for servicing and
proper operation.
3
Correctional Holding
"Heavy Duty"
tough transportation
Refer to cleaning
and