Vulcan-Hart CBFT Series Installation & Operation Manual

Vulcan-Hart CBFT Series Installation & Operation Manual

Correctional heated holding cabinets

Advertisement

CBFT SERIES
CORRECTIONAL
HEATED HOLDING
CABINETS
MODELS:
CBFT
ML-152028-0000Z
CBFTHS
ML-152029-0000Z
VULCAN
DIVISION OF ITW FOOD EQUIPMENT GROUP, LLC
www.vulcanequipment.com
INSTALLATION &
OPERATION MANUAL
Vulcan ©2014 All Rights Reserved
3600 NORTH POINT BLVD.
BALTIMORE, MD 21222
F-47102 (06-14)

Advertisement

Table of Contents
loading

Summary of Contents for Vulcan-Hart CBFT Series

  • Page 1 INSTALLATION & OPERATION MANUAL CBFT SERIES CORRECTIONAL HEATED HOLDING CABINETS MODELS: CBFT ML-152028-0000Z CBFTHS ML-152029-0000Z VULCAN 3600 NORTH POINT BLVD. DIVISION OF ITW FOOD EQUIPMENT GROUP, LLC BALTIMORE, MD 21222 www.vulcanequipment.com F-47102 (06-14) Vulcan ©2014 All Rights Reserved...
  • Page 2: Important For Your Safety

    F-47102 (06-14) CBFT SERIES IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL ELECTRICAL EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START- UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. FOR YOUR SAFETY...
  • Page 3: Table Of Contents

    F-47102 (06-14) CBFT SERIES TABLE OF CONTENTS IMPORTANT FOR YOUR SAFETY ........1 GENERAL .
  • Page 4: General

    F-47102 (06-14) CBFT SERIES GENERAL INTRODUCTION Vulcan Heated Holding Cabinets are It is suggested that you thoroughly read produced with quality workmanship and this entire manual and carefully follow all material. Proper installation, usage, and of the instructions provided. maintenance of your cabinet will result...
  • Page 5: Electrical Requirements

    F-47102 (06-14) CBFT SERIES ELECTRICAL REQUIREMENTS ELECTRICAL CODES & STANDARDS: cabinets cabinet must installed equipped with a three-prong plug. It accordance with: is imperative that this plug must be connected into a properly grounded In the United States of America: three-prong receptacle.
  • Page 6: Operation

    F-47102 (02-14) CBFT SERIES OPERATION CONTROLS ON/OFF SWITCH The cabinet is pre-set/programmed at the factory at a recommended temperature of 165⁰ F. OPERATING INSTRUCTIONS Once the cabinet has been properly UNLOADING: installed by competent service people, Once cabinet has been transported,...
  • Page 7: Cleaning

    F-47102 (02-14) CBFT SERIES CLEANING Clean the interior of the cabinet Always UNPLUG with a mild soap and water. ELECTRICAL POWER SUPPLY Never use harsh chemicals or before cleaning. abrasive pads to clean the cabinet. Keep the cabinet clean and sanitary so Rinse and dry with a soft dry it will meet your local sanitation code.
  • Page 8: Maintenance

    F-47102 (02-14) CBFT SERIES PRESERVING & RESTORING: HEAT TINT: Special stainless steel polishing Darkened areas, called “heat tint,” may cleaners can preserve and restore the appear on stainless steel exposed to protective film. excessive heat. Excessive heat causes Preserve the life of stainless steel with a the protective film to thicken.
  • Page 9: Troubleshooting

    Defective fan. Contact Authorized Service Provider. SERVICE & PARTS INFORMATION To obtain Service and Parts information concerning this model, contact Vulcan-Hart Service Department at the address listed on the front cover of this manual or refer to our website: www.vulcanequipment.com for a complete listing of Authorized Service and Parts depots.
  • Page 10 F-47102 (02-14) CBFT SERIES...
  • Page 11 F-47102 (02-14) CBFT SERIES...

This manual is also suitable for:

CbfthsMl-152028-0000zMl-152029-0000z

Table of Contents