Planning The System - Bosch MAP 5000 Instruction Manual

6 en | Introduction
–
–
–
–
Danger!
Electric shock
Danger of electric shock if live parts are touched. The alarm system is designed for an IT-
power distribution system (230 V). Switch off the power supply of the alarm system before
carrying out maintenance or installation work.
1.5

Planning the system

MAP control panel enclosure kit
The ICP-MAP0111 panel enclosure kit is the main system enclosure. This enclosure is designed
to contain the following components:
–
–
–
–
–
–
–
–
–
Use the ICP-MAP0120 expansion enclosure kit when the system requirements for power and /
or other remote devices exceed the capacity provided by the ICP-MAP0111 panel enclosure
kit 6.
MAP expansion enclosure kit
The ICP-MAP0120 expansion enclosure kit is designed to contain the following components:
–
–
–
–
–
–
Use the ICP-MAP0115 power enclosure kit when system power requirements exceed the
power capacity of the ICP-MAP0111 panel enclosure kit
MAP power enclosure kit
The ICP-MAP0115 power enclosure kit is designed to contain the following components:
–
–
–
–
2018.08 | 23 | F.01U.168.332
Follow anti-static procedures when handling system components. Ensure that you are
properly grounded to discharge any static charge before you work with system
components.
Install all components in dry, maintained interior rooms.
Install the system in a centrally located room that is near the AC Power MAINS.
Because the panel is permanently connected equipment, a readily accessible disconnect
device must be included into the building installation wiring.
ICP-MAP5000 main panel
ICP-MAP0007 DE module
ICP-MAP0010 LSN gateway
ICP-MAP0012 CAN splitter
AT 2000 communicator 2
IPP-MAP0005 power supply
ICP-MAP0065 AC terminal block
ICP-MAP0050 control panel enclosure tamper switch
Two batteries (maximum 45 Ah each)
IPP-MAP0005 power supply
ICP-MAP0010 LSN gateway
ICP-MAP0012 CAN splitter
ICP-MAP0065 AC terminal block
ICP-MAP0055 expansion enclosure tamper switch
Two batteries (maximum 18 Ah each)
IPP-MAP0005 power supply
ICP-MAP0065 AC terminal block
ICP-MAP0050 control panel enclosure tamper switch
Four batteries (maximum 40 Ah each)
1
1
1
1
3
4
3
5
1
4
3
4
Installation manual
6 .
Bosch Sicherheitssysteme GmbH
MAP 5000