BIIFLM08 (Published) Book specs- Dates: 20151104 / 20151104 / 20151104 Lang: ENG01 Applic: IFL IH4
Bearing Housing Components and Installation
Figure 1: Bearing housing
G.
Use Locktite 242.
H.
Grease inlet for the rear bearing
J.
When you install new seals, make sure that they point in the directions shown. The installation sequence: Install one
seal into the rear of the seal holder. Install the seal holder. Install the two remaining seals.
K.
Fill this space with grease.
.
Bearing Housing Components and Installation
Cross Section: AA
Legend
81
PELLERIN MILNOR CORPORATION