Step 6: Perform Initial Software Configuration; Enter Configuration Mode - Juniper MX204 Quick Start Manual

Step 6: Perform Initial Software Configuration

Enter Configuration Mode

Copyright © 2018, Juniper Networks, Inc.
Switch on the external circuit breakers to provide voltage to the DC power source
10.
cable leads.
Power on the power supply at source. Observe the power status LED on the router. If
11.
a DC power supply is installed correctly and functioning normally, the status LED lights
green steadily.
If the status LED indicates that the power supply is not functioning normally, repeat
the installation and cabling procedures.
Figure 19: Connecting a DC Power Cable to an MX204 DC Power Supply
This procedure connects the router to the network but does not enable it to forward
traffic. For complete information about configuring the router to forward traffic, including
examples, see the Junos OS configuration guides.
To configure the software:
Enter Configuration Mode on page 19
Configure User Accounts and Passwords on page 20
Configure System Attributes on page 20
Commit the Configuration on page 21
Verify that the router is powered on.
1.
Log in as the root user. There is no password.
2.
Start the CLI.
3.
root# cli
root@host>
Enter configuration mode.
4.
root@host> configure
[edit]
root@host#
Step 6: Perform Initial Software Configuration
19