Siemens SINUMERIK 840D sl Function Manual page 817

Activation and deactivation
End-of-motion criterion IPOBRKA and precise time of activation.
For part program execution:
● The braking ramp end-of-motion criterion can be activated via the NC command
● The precise time of activation is defined in setting data
● IPOBRKA is deactivated when an axis end-of-motion criterion FINEA, COARSEA or
● The NC command ADISPOSA can be used to program the size of the tolerance window
For technology cycles:
● The braking ramp end-of-motion criterion can be activated via the synchronized action
● IPOBRKA is deactivated when the axis end-of-motion criterion FINEA, COARSEA or
● The size of the tolerance window for the braking ramp end-of-motion criterion can be
Extended Functions
Function Manual, 03/2009, 6FC5397-1BP10-4BA0
IPOBRKA.
SD43600 $SA_IPOBRAKE_BLOCK_EXCHANGE
IPOENDA is next programmed for the axis.
for the braking ramp end-of-motion criterion and this is defined by means of setting data
SD43610 $SA_ADISPOSA_VALUE[axis]:
IPOBRKA.
IPOENDA is next programmed for the axis in a synchronized action.
programmed via the synchronized action ADISPOSA.
Note
For further information about programming positioning axes, see:
References:
/PG/ Programming Manual, Fundamentals, Section "Feedrate control and spindle motion"
/PGA/ Programming Manual, Advanced, Section "Special motion commands"
Positioning Axes (P2)
Block change
817