Siemens SINUMERIK 840D sl Function Manual page 1076

NC/PLC Interface Signals (Z2)
Manual and handwheel travel
DB21, ...
DBB40, 46, 52
Bit 7, 6 Plus and minus travel commands (for geometry axis)
Signal state 0 or A travel command in the relevant axis direction has not been given or a traverse movement has
edge change 1 → 0 been completed.
•
•
•
Application To release clamping of axes with clamping (e.g. on a rotary table).
example(s)
Note:
If the clamping is not released until the travel command is given, these axes cannot be operated
under continuous path control!
Corresponding to .... DB21, ... DBX12.7 and/or DBX12.6 ff
(Traverse key plus and traverse key minus for geometry axis)
DB21, ... DBX 40, 46, 52 Bit 5 (Traversing request plus/minus)
DB21, ...
DBB41, 47, 53 Active machine function for geometry axis (1, 2, 3)
Bit 0-6 INC1, ..., continuous
Edge evaluation: No
Signal state 1 or The PLC interface receives a signal stating which JOG mode machine function is active for the
edge change 0 → 1 geometry axes.
The reaction to actuation of the traverse key or rotation of the handwheel varies, depending on
which machine function is active.
Signal state 0 or The machine function in question is not active.
edge change 1 → 0
Corresponding to .... DB21, ... DBB13 ff (machine function INC1, ..., continuously for geometry axis)
1076
JOG mode:
The travel command is reset depending on the current setting "jog or continuous mode" (see
DB21, ... DBX12.7 or DBX12.6 ff).
While traversing with the handwheel.
REF mode:
When the reference point is reached.
AUT/MDA mode:
The program block has been executed (and the next block does not contain any coordinate
values for the axis in question).
Cancel by "RESET", etc.
NST DB21, ... DBX25.7 (axes disable) is active.
Signal(s) updated: Cyclically
Function Manual, 03/2009, 6FC5397-1BP10-4BA0
Extended Functions