Juniper WLC Series Complete Hardware Manual page 48

Complete Hardware Guide for WLC100 Wireless LAN Controller
40
To connect and configure a controller by using the WebView interface:
Connect the Ethernet cable from the Ethernet port on the PC to the port labeled
1.
the front panel of the controller.
These ports are configured as the DHCP server with the default IP address, 192.168.1.1.
The controller can assign an IP address to the management PC in the IP address range
192.168.1.2 through 192.168.1.253.
From the PC, open a Web browser, type http://192.168.100.1 in the address field, and
2.
press Enter.
On the WebView login page, type admin as the username, leave the password field
3.
blank, and click Login .
Click on the top left.
4. Configure
Click Quick Start under the
5.
On the Welcome page, click
6.
On the Configuration Type page, select the management platform you plan to use to
7.
configure and manage the device in the future using the drop-down menu. Select
to disable web-based management and
.
Next
(Optional) On the System Name page, modify the system name or retain the default
8.
name (that is, WLC100). Click
(Optional) On the Country Code page, modify the country code or retain the default
9.
country code (that is, US). Click
On the IP Configuration page, set the system IP address, IP mask bits, and default
10.
route. Click .
Next
On the Password page, enter a password for future management access to the system
11.
and reenter the password. Click
(Optional) On the Date and Time page, modify the date, system time, and time zone,
12.
and enable Network Time Protocol (NTP) and daylight savings time by selecting the
appropriate check boxes. Click
(Optional) On the Wireless Services page, select the primary service authentication
13.
type and whether you want to create guest service using the drop-down menu. Click
Next .
(Optional) On the Primary Service page, set the service name and Service Set Identified
14.
(SSID), and whether you want to enable or disable encryption of data traffic between
the controller and the access point using the drop-down menu. Click
(Optional) On the Add default VLAN tags page, select
15.
if you want to add tags for default VLAN or select
you do not want to add tags for default VLAN. Click
On the Access Point page, select
16.
configure an access point or select
WIZARDS menu on the left.
.
Start
to enable web-based management. Click
No
Next .
.
Next
.
Next
.
Next
No
Next
using the drop-down menu if you want to
Yes
using the drop-down menu if you do not want
No
Copyright © 2013, Juniper Networks, Inc.
.
Next
using the drop-down menu
Yes
using the drop-down menu if
.
on
1
Yes