Controllers - Juniper WLC Series Complete Hardware Manual

Complete Hardware Guide for WLC100 Wireless LAN Controller
Table 5: Network Port Connector Pinout Information (continued)
Pin
7
8
Related
Documentation
RJ-45 Console Port Connector Pinout Information for WLC100 Wireless LAN Controllers
Table 6: Console Port Connector Pinout Information for WLC100 Controllers
Pin Signal
1 RTS Output
2 DTR Output
3 TxD Output
4 Signal Ground
5 Signal Ground
6 RxD Input
7 DCD Input
8 CTS Input
12
Signal
TRP4+
TRP4-
RJ-45 Console Port Connector Pinout Information for WLC100 Wireless LAN Controllers
on page 12
RJ-45 to DB-9 Female Adapter Pinout Information for WLC100 Wireless LAN Controllers
on page 13
Front Panel of WLC100 Wireless LAN Controllers on page 5
The RJ-45 console port on WLC100 controllers is an RS-232 serial interface that uses an
RJ-45 connector to connect to a console management device. The default baud rate for
the console port is 9600 baud.
Table 6 on page 12 provides the pinout information for the RJ-45 console connector. An
RJ-45 to DB-9 female adapter is supplied with these controllers.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to a controller, use a combination
of the RJ-45 to DB-9 female adapter and a USB to DB-9 male adapter. You
must provide the USB to DB-9 male adapter.
Description
Request to send
Data terminal ready
Transmit data
Signal ground
Signal ground
Receive data
Data carrier detect
Clear to send
Description
Transmit/receive data pair 4
Transmit/receive data pair 4
Copyright © 2013, Juniper Networks, Inc.