Juniper WLC Series Complete Hardware Manual page 42

Complete Hardware Guide for WLC100 Wireless LAN Controller
34
Ensure that you have the following parts and tools available:
3 mounting screws rated to support up to 2.8 lb (12.7 kg) (not provided)
Phillips (+) screwdriver, number 2
To install the controller on a wall:
Remove the controller from the shipping carton (see
1.
LAN Controllers" on page
NOTE: Wireless controllers are shipped with rubber feet attached. The
rubber feet are necessary to stabilize the controllers on the desk or other
level surface.
Place the controller on a flat and level surface with the Juniper Networks logo
2.
embossed on the top cover facing up.
Drill three holes on the wall as shown in
3.
screws in them.
Use mounting screws that have a diameter of less than 4.5 mm and are rated to
support up to 2.8 lb (12.7 kg).
Turn the screws only part way in, leaving about 1/4 in. (6 mm) between the head
of the screw and the wall.
Figure 6: Measurements for Installing Mounting Screws
Grasp the sides of the controller, lift it, and position it over the mounting screws
4.
installed on the wall.
Mount the controller on the mounting screws facing front panel upward, and slide it
5.
downward until it locks in place as shown in
28).
Figure 6 on page 34
Figure 7 on page
"Unpacking WLC100 Wireless
and install mounting
35.
Copyright © 2013, Juniper Networks, Inc.