Recording/Playing Aw2400 Mix Operations On An External Sequencer - Yamaha AW2400 Owner's Manual

Connecting to External Equipment
■ Transmit program
changes to switch scenes
1
Connect the AW2400 and your sequencer
as shown in the diagram below.
AW2400
MIDI
IN
MY16-mLAN
IEEE1394 cable
2
Use the Work Navigate section [MIDI] key to
access the MIDI screen Setting 1 page.
3
Set the connector/port and channel to be
used for program change message recep-
tion in the RX PORT and CHANNEL fields.
4
Turn the PROGRAM CHANGE (RX) field ON/
OFF button on.
If you want to receive program change messages on all
channels regardless of the MIDI receive channel set-
ting, also turn the OMNI (RX) button on.
This sets up the AW2400 to receive MIDI program
change messages.
5
Transmit a program change message from
your sequencer to the AW2400 on the MIDI
channel that you selected.
The scene assigned to that program change number
will be recalled.
HINT
• If you insert program changes into the appropriate locations
of your sequencer track, scenes will be recalled automatically
as the AW2400 and your sequencer run in synchronization.
20
202
AW2400 Owner's Manual
Workstation synthesizer
with a built-in sequencer
Program
changes
MIDI
OUT
or
USB cable
or
Computer-based
sequencer application
Recording/playing AW2400 mix oper-
ations on an external sequencer
Here's how you can synchronize the AW2400 and your
external sequencer, and use the sequencer to record/play
the fader and pan operations you perform on the AW2400.
Since operating the AW2400's mix parameters will cause
a large number of control change messages to be transmit-
ted, we will use MIDI Clock (which uses less data) as the
synchronization signal rather than MTC.
1
Connect the AW2400 and your sequencer
as shown in the following diagram.
MIDI Clock
Control
changes
MIDI OUT/
THRU
AW2400
MIDI
IN Control
changes
or
MY16-mLAN USB cable
or
IEEE1394 cable
2
Use the Work Navigate section [MIDI] key to
access the MIDI screen Setting 2 page. Turn
on the MASTER button in the MTC field, and
turn on the MIDI CLOCK button in the SYNC
OUT field.
● Example settings for synchronization
using MIDI Clock and Start/Stop/Con-
tinue
MIDI
IN
Workstation synthesizer
with a built-in sequencer
MIDI
OUT
Computer-based
sequencer application