Stereo Output Channel - Yamaha AW2400 Owner's Manual

Displaying the mix parameters for individual channels

■ Stereo output channel

E
A
D
F
■ Bus master channels 1, 2
E
A
12
D
F
■ AUX send master channels 1–4
E
A
B
D
F
106
AW2400 Owner's Manual
■ Effect send master channels 1–4
G H
A
F
K
1 INITIALIZE button
Initializes all parameters for the currently displayed chan-
nel.
G
B Channel Pair Indicator
Indicates whether the displayed channel is part of a pair or
not. You can also move the cursor to this indicator and
press the [ENTER] key to turn pairing on or off.
C PHASE button, GATE button
• PHASE button ..... Switches the phase (polarity) of the
K • GATE button (input channels only)
G
D ATT button, EQ button
• ATT button........... Move the cursor to this knob and
• EQ button ............ Move the cursor to this button and
K
E
HINT
• Pressing the [F1] key while holding the Display section [SHIFT]
key has the same effect as the INITIALIZE button.
input signal. Move the cursor to this
button and press the [ENTER] key
to switch between normal (N : NOR-
MAL) and reverse (R : REVERSE)
polarity.
................. Move the cursor to this button and
press the [ENTER] key to turn the
gate for that channel on or off. Refer
to "Using the Gates" on page 151 for
details.
use the [DATA/JOG] dial or [INC]/
[DEC] keys to adjust the attenuation
as required (range: -96–+12dB).
This capability can be used to atten-
uate the pre-EQ signal level to pre-
vent clipping in the EQ stage.
press the [ENTER] key to turn the
EQ for that channel on or off. Refer
to "4-band EQ" on page 149 for
details.
K