Input Channel - Yamaha AW2400 Owner's Manual

Inserting an Effect Into a Channel
5
Use the [DATA/JOG] dial or [INC]/[DEC]
keys to select the desired effect and/or I/O
card channel, then press the [ENTER] key.
When EFF1–4 is selected the corresponding effect
will be inserted in the signal path.
The signal flow is as follows.
●
INSERT EFF = EFF 1
PHASE GATE
■ External effect inserted pre-EQ

(input channel)

When SLOT1–16 is selected an external effect processor
14
can be inserted into the channel via the selected I/O card
channel. In this case the signal flow is as follows.
●
INSERT EFF = SLOT1
External effect
processor
Output channel = 1
PHASE GATE
120
AW2400 Owner's Manual
Insert points
Effect 1
EQ
ATT ON
Input channel = 1
I/O card
EQ
ATT ON
■ Internal effect inserted pre-EQ
(input channel)
6
To select the insert point move the cursor
to the symbol below INSERT EFF on the
display and press the [ENTER] key.
Press [ENTER] repeatedly to sequentially select the
pre-EQ → post-EQ pre-fader → post-fader insert
points.
When an effect and compressor are both inserted at the
same point you can move the cursor directly to the
insert point and press the [ENTER] key to swap the
positions of the effect and compressor.
7
Call the EFFECT screen FX Edit page or FX
Lib. page to adjust the internal effect mix
balance (the balance between the effect and
LVL
direct signals).
8
Use the MIX BALANCE field knob to bal-
ance the effect and direct sound as
required.
A setting of 0% produces only the direct sound while a
setting of 100% produces only the effect sound.
HINT
• Refer to "Editing Effects" on page 121 for details on the
EFFECT screen FX Edit page.
LVL