Cyclic Synchronous Velocity Mode - Omron 1 S Series User Manual

6 Basic Control Functions
6-4

Cyclic Synchronous Velocity Mode

In this mode of operation, the controller has a path generation function (an operation profile calculation
function) and it gives the target velocity to the Servo Drive in cyclic synchronization.
The Torque offset (60B2 hex) can be used as the torque feed-forward amount.
Cyclic Synchronous Velocity Mode Configuration
The following diagram shows the configuration of the Cyclic synchronous velocity mode.
Torque offset (60B2 hex)
Velocity offset (60B1 hex)
Target velocity (60FF hex)
Velocity actual value (606C hex)
Torque actual value (6077 hex) (= Torque demand)
Position actual value (6064 hex)
The following diagram shows the configuration of the control function of the Cyclic synchronous velocity
mode.
Velocity offset (60B1 hex)
Target velocity (60FF hex)
Torque offset (60B2 hex)
Max torque (6072 hex)
6 - 12
+
+
+
+
Control
function
1S-series with Built-in EtherCAT Communications and Safety Functionality User's Manual (I621)
+
+
Velocity Torque
control control
Velocity
detection
Position actual value (6064 hex)
Velocity actual value (606C hex)
Torque actual value (6077 hex)
M
E