Samson 3730 Series Mounting And Operating Instructions page 7

Firmware modification
The fault alarm contact is triggered by the condensed status of the positioner.
It is always active with "Maintenance alarm" condensed status.
If Code 32 is set to Yes : Also active with "Function check" condensed status
If Code 33 is set to Yes : Also active with "Maintenance required/Mainte-
nance demanded" condensed status
The "Function check" condensed status is additionally set for Test A1, A2,
fault alarm output and position transmitter.
The min./max. values of the temperature monitoring can be reset.
7
EB 8384-3 EN