Mitsubishi Heavy Industries MHI FDU71VNXVF1 Technical Manual page 349

Step 8
8. Insert the plastic band with clip on the designated
place (2 places), and fix the heater.(Model B,C only)
Model B, C
Step 9
9. Lay down the wiring on the same route of fan motor wiring, and fix the wire with
attached plastic band at the same place where the fan motor wiring is banded.
Model A
Band
<Note>
Fan motor wiring is banded on the bracket so that it doesn't loosen.
Do not loose the band for the motor wiring to band the heater wire together but use the attached plastic band.
<Note>
1) Do not fasten the heating part with the
plastic band.
There is a marking on the end of heating
part.
Marking
Fan motor wiring
Heater
Heater
2) When the heater is laid down correctly,
�
Model B
Band
348
- -
'12 • PAC-T-178
the end of heating part comes to the
corner of the base.
Marking
�
Model C
Band