Parker Gemini GT6 Series Hardware Installation Manual page 74

Additional Steps to Ensure Compliance
Mains Fuses
EMC – Electromagnetic Compatibility Directive – 89/336/EEC
To meet the requirements of regulatory agencies, you must follow the installation
guidelines presented below.
Instructions for installing mains fuses were presented in Connecting AC Power in
Chapter 2 Installation.
In order to meet the requirements of the Electromagnetic Compatibility Directive
89/336/EEC, the entire system must comply: motor, drive, cabling, and peripher-
als. The installation of the product must include the following items.
EMC Cabling
For electromagnetic compatibility, you must use Parker Compumotor CE cables.
EMC Motor
For system CE compliance, you must use an EMC-ready motor, or a motor that
has demonstrated acceptable EMC performance.
NOTE: Motors may bear the CE mark. This mark indicates the motor meets the
requirements of construction and safety—not EMC compliance.
Motors with shielded cabling or pipe thread style cabling options allow the easiest
integration into machines required to bear the CE mark for EMC.
Varistors
You must install varistors or other voltage surge limiting devices in order to meet
the requirements of EN61000-4-5. Place a Harris Semiconductor V275LA2Ø or
equivalent varistor from line to line, and from lines to earth before the mains filter,
as shown in the EMC Installation drawing later in this appendix.
Mains Filters
You must install a mains filter. The table below lists recommended filters for
Gemini Drives.
Filter: GT6-L5
1
6EP1 X
1, 3
10EP1 X
2
FN2070-10-06 X
2
FN2070-12-06 X
2, 3
FN2070-16-06 X
Product with applicable mains filter denoted by "X"
1 Corcom; 2 Schaffner;
3 Available from Compumotor:
GT6-L8 GT6-U5 GT6-U8
X
X X X
X X X
X X X
X X X
10 amp filter – part number 47-016140-01
16 amp filter – part number 47-017900-01
Appendix C – Regulatory Compliance: UL and CE
73