Parker Gemini GT6 Series Hardware Installation Manual page 63

Gemini GC-50 – 50 Pin Connector
62
Gemini GT6 Hardware Installation Guide
The Gemini GC-50 is a 50 pin breakout module that connects directly to the 50 pin
DRIVE I/O connector. Dimensions are shown below.
Connect wires to the GC-50 before installing it in the Gemini drive. This will avoid
damage that may be caused by wiring the GC-50 while it is attached to the drive.
GC-50
Dimensions in inches (millimeters)
GC-50 Dimensions
CAUTION
3.05 (77.5)
S 35 36 37 38 39 40 41 42 43
18 19 20 21 22 23 24 25 26 27
1 2 3 4 5 6 7 8 9 10 11
44 45 46 47 48 49 50
28 29 30 31 32 33 34
12 13 14 15 16 17
0.138 (3.5)