Bosch SHP65TL5UC Repair Instructions page 66

6.1.4 Error code / troubleshooting chart
Error
Description
Code
E:00 No errors
E:01 Faulty pump relay
E:02 Faulty heater relay
E:05 Faulty water switch relay
E:06 Door latch Hall sensor not
detected
Defective door latch Hall sensor
E:08 Heat pump detects low water
level
E:09 Faulty heater circuit (open -
circuited)
702_58300000170749_ara_en_c
Part DW Symptoms
No errors
Wash cycle abruptly ends with Sanitized LED lit
Dishwasher runs without heating / heater error
Water switch runs continually
DW won't run & Clean LED is flashing
Not heating
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary
information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
(seen during wash cycles)
Replace power module (located in base).
Align door latch above Hall sensor (inside inner door)
Check continuity / connections between door switch (q2)
and power module.
With door closed, measure voltage across door latch Hall
sensor connector. If > 10V, replace Hall sensor. If < 10 V,
replace power module.
Check water supply & repair any leaks. Check for kinks in
inlet hoses. Turn over pots / bowls collecting water.
Check continuity between water inlet valve (k2) and power
module.
Measure voltage across water inlet valve terminals (k2)
during step 1 of customer service test program. If ≈ 120V,
replace water inlet valve. If not ≈ 120V, replace power
module.
Check continuity between heat pump heating element (e1)
and power module.
Measure heat pump heating element (e1) resistance, which
should be ≈ 8.9Ω @ room temp. If not, replace heat pump.
If so, replace power module.
Solution
Page 66 of 82