Bosch SHP65TL5UC Repair Instructions page 41

TIP: When replacing an inner door – dishwashers cannot
be identified since their serial labels are attached to the
inner doors being replaced:
1. Have customers write their model and serial #'s in their
Use & Care manuals.
2. Legibly write the model and serial #'s on the ss surface
(near the bitumen at the dispenser) of the replacement
inner door using a fine tip black permanent marker.
5.1.4.7 To remove lower door seal
Tools needed: T20 Torx & #2 Phillips screwdrivers, pliers &
gloves.
702_58300000170749_ara_en_c
The lower door seal
attached by two of the four
inner door screws. It is
removed along with the inner
door.
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary
information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
1. Remove inner door – section 5.11. The lower door seal
will be loose since it's two (2) screws were removed when
the inner door was removed (below left). If the seal sticks
to the inner door, separate the seal from the door by hand
(below left).
2. Remove lower door seal (below right).
CAUTION: Inner door edges (at the hinge) are sharp! Use
gloves, cover inner door edges and remove lower door
seal carefully.
5.1.5 Pulling out dishwashers
Follow these instructions to pull out dishwashers for side or
bottom front access.
is
5.1.5.1 Disconnect & pull out dishwasher
Tools needed: #2 Phillips screwdriver and pliers or wrench.
1. Remove base insulation (on models with insulation).
Page 41 of 82