Door Latch - Bosch SHP65TL5UC Repair Instructions

5.3.3 To reinstall vapor barriers (SHP / SHV)
Vapor barriers are factory installed with dispensers to protect
them from the unlikely event water gets inside dishwasher doors.
Vapor barriers must be installed on replacement dispensers,
whether using existing or replacement barriers.
Vapor barriers have a two-sided adhesive strip for installing them
onto the front of dispensers. The portion of the barrier above the
adhesive strip is folded over (at a 90º angle) and held in place on
top of the dispenser by the cable guide. The barrier has a crease
for folding the top of it over.
For replacement vapor barriers, zip off the cover tape from the
vapor barrier adhesive strip, fold the top of the barrier at a right
angle toward the dishwasher, place the strip onto the dispenser
and press the strip over it's entire length until it sticks.
For existing vapor barriers, carefully remove them from old
dispensers (to avoid removing adhesive), place the strip onto the
dispenser and press the strip over it's entire length until it sticks.
CAUTION: Not replacing vapor barriers could allow water
to damage dispensers.
702_58300000170749_ara_en_c
Fold top of
vapor barrier
90º toward
dishwasher
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary
information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
5.4

Door latch

The door latch is mounted on top of the tank and contains a
magnet, not a microswitch.
senses the magnet when the door or closed.
Confirm whether the latch is misaligned before replacing the latch
or sensor. Check the sensor with a magnet to confirm if it's
properly sensing the latch (see section 6.3.1.1).
5.4.1 To remove door latch Hall Effect sensor
Tools required: T10 Torx, T20 Torx & flat blade screwdrivers.
1. Remove outer door – section 5.1.2.1.
2. Remove fascia panel -- section 5.1.2.2.
3. Disconnect wire harness from sensor (below left).
4. To remove sensor, open door and remove (2) T-10 Torx
screws from the top center of the door (below center).
A Hall-effect sensor in the door
Page 49 of 82