Bosch SHP65TL5UC Repair Instructions page 45

5.2.2 Removing Integra controls (SHP / SHX / SHV)
Controls are easily removed from fascia panels by prying plastic
tabs.
Tools needed: T-20 Torx & flat blade screwdrivers.
1. Remove fascia panel – section 5.1.2.3.
remove outer door first.
2. Disconnect short wire harnesses from control and on/off
switch (see below). Models with touch screens won't have
an on/off switch and harness (i.e. you'll only be
disconnecting one harness).
3. Remove controls by carefully prying clips from one side to
the other (below left) and gently lifting controls up as you
pry clips.
4. When reassembling fascia panels to doors, make sure
fascia panel tabs enter outer door slots.
CAUTION – 80% of all controls returned
for analysis check out OK.
issues are due to loose connections and
error codes for other parts.
702_58300000170749_ara_en_c
If needed,
Most control
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary
information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
5.2.3 Installing Integra controls (SHP / SHX / SHV)
Using the following procedure will make controls (operating
modules) easier to install and will insure they're securely
mounted – with all four (4) plastic latches properly latched.
1. Place the operating module vertically (upright) in the fascia
panel (below).
2. Apply even downward pressure at the center of the
operating module (below left).
3. Apply downward pressure on the operating module moving
outward from it's center (below right).
4. Check the back of the fascia panel to insure all four (4)
plastic latches are properly placed and snapped into place
(below).
Page 45 of 82