Controls - Bosch SHP65TL5UC Repair Instructions

5.2

Controls

5.2.1 Fascia panel mounted controls (front button models)
Controls are easily removed from fascia panels by prying plastic
tabs.
Tools needed: T-20 Torx & flat blade screwdrivers.
1. Remove fascia panel – section 5.1.2.2.
remove outer door first.
2. Disconnect short wire harnesses from control and on/off
switch (see below).
4
1. Connector
3. Control jumper harness
5. Handle tray
702_58300000170749_ara_en_c
If needed,
1
1
2
3
6
5
2. On/off switch harness
4. On/off switch
6. Control
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary
information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
3. Remove handle trays (1) before removing controls (2). To
remove handle trays, carefully pry in plastic clips.
1
2
4. Remove controls by carefully prying clips from one side to
the other (below left) and gently lifting controls up as you
pry clips.
5. When reassembling fascia panels to doors, make sure
fascia panel tabs enter outer door slots.
CAUTION – 80% of all controls returned
for analysis check out OK.
issues are due to loose connections and
error codes for other parts.
Most control
Page 44 of 82