Bosch SHP65TL5UC Repair Instructions page 39

5.1.4 Bottom front access
Bottom front access is needed for parts such as aqua sensors,
drain pumps and floats. The outer door, inner door and base
cover must be removed.
Follow these instructions to prepare dishwashers for bottom front
access.
5.1.4.1 Bottom front access
Tools needed: T20 Torx & #2 Phillips screwdrivers and pliers.
1. Remove outer door – section 5.1.2.1.
2. Remove toe kick – section 5.1.4.2. Pull dishwasher out
enough to clear hinges.
3. Remove base cover – section 5.1.4.3. This eliminates
disconnecting and reconnecting all wire harnesses.
4. Remove overflow trough and support – section 5.1.4.5.
5. Remove inner door – section 5.1.4.6.
6. Remove lower door seal – section 5.1.4.7.
5.1.4.2 To remove toe kick
Tools needed: T20 Torx & #2 Phillips screwdrivers.
1. Where necessary for access, remove outer door –
section 5.1.2.1.
2. Remove decorate screw caps and save for reuse.
3. Remove two (2) Phillips #2 screws and tilt bottom of toe
kick out and up from dishwasher (below). Depending on
the model, there may or may not be mounting brackets.
702_58300000170749_ara_en_c This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary
information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
TIP: Removing toe kicks aren't necessary for left / right
side access, rear access or for flipping dishwashers
upside-down.
5.1.4.3 To remove base covers
Tools needed: T20 Torx & #2 Phillips screwdrivers and pliers.
1. Remove toe kick – section 5.1.4.1.
2. Remove outer door – section 5.1.2.1.
3. Remove base insulation (on models with insulation).
4. Remove two (2) base cover screws.
5. Tilt top of base cover forward and lift up until slots clear
base (below).
Page 39 of 82