Texas Instruments AFE79 Series Programming & User Manual page 64

Revision History
DATE
March 2020
April 2020
May 2020
64
Revision History
Added a reference to Macro Register Map section in Macro Interface
Protocol section.
Changed the designations of top level designs from 12 and 34 to Core12
and Core34 respectively across the document.
Changed description of Channel in Nomenclature section.
Added Macros List table in List of Macros section.
Added a reference to System Configuration section in Tune System
section.
Changed the Opcode from 0x42 to 0x48 in TX Tone Generator
Configuration section.
Added an example to description of Operand 2 in AGC Detector Time
Constant Macro section.
Changed the Opcode from 0x5A to 0x5B in AGC Digital Detector
Absolute Time Crossing Macro section.
Changed the description of Operand 2 in AGC Digital Detector Absolute
Time Crossing Macro section.
Changed the description of Operand 2 in AGC External-AGC
Configuration Macro section.
Changed the description below the table in AGC Detectors reset by
GPIO Control Macro section.
Changed the description of Operand 3 in AGC Internal-AGC Controller
Configuration Macro section.
Changed the description below the table in AGC Internal-AGC Controller
Configuration Macro section.
Changed the Opcode from 0x60 to 0x5F in AGC Min/Max DSA
Attenuation Configuration Macro section.
Added description to AGC Customer RF Macro section.
Added description to AGC External LNA Gain Control Configuration
Macro section.
Added description to LNA Temperature Configuration Macro section.
Added Error Reporting section in following sections.
1. System Channel Configuration
2. TDD/FDD Configuration
3. System Bands Configuration
4. RX Interface Rate Configuration
5. FB Interface Rate Configuration
6. TX Interface Rate Configuration
7. RX ADC Rate configuration
8. FB ADC Rate configuration
9. TX DAC Rate Configuration
10. Channel Frequency Resolution
11. TX Channel Frequency Set
12. RX Channel Frequency Set
13. FB Channel Frequency Set
14. RX-FB Nyquist Zone Configuration
15. TX Nyquist Zone Configuration
16. Update RX Channel Frequency Set
17. Update FB Channel Frequency Set
18. Tune System
19. RX DSA Gain Phase Factory Calibration Macro
20. TX DSA Gain-Phase Factory Calibration Macro
Added Macro Usage section.
Changed PLL Register Map section.
Changed AFE79xx Macro Interface figure.
Changed Fields within Macro Status Registers figure.
Changed Macro Interface Categories table.
Copyright © 2020, Texas Instruments Incorporated
REVISION
www.ti.com
NOTES
Draft release
SBAU337 – May 2020
Submit Documentation Feedback