Table of Contents
Advertisement
IP Configuration: RIPv2
Configuring RIP
STEP 7
STEP 1
STEP 2
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
•
User Defined Metric—Enter the value of the metric.
Click Apply. The settings are written to the Running Configuration file.
RIPv2 Settings
To configure RIP on an IP interface:
Click IP Configuration > RIPv2 > RIPv2 Settings.
RIP parameters are displayed per IP interface. To add a new IP interface, click Add and enter
the following fields:
•
IP Address—Select an IP interface defined on the Layer 2 interface.
•
Shutdown—Keep RIP configuration on the interface, but set the interface to inactive.
•
Passive—Specifies whether sending RIP route update messages is allowed on the
specified IP interface. If this field is not enabled, RIP updates are not sent (passive).
•
Offset—Specifies the metric number of the specified IP interface. This reflects the
additional cost of using this interface, based on the speed of the interface.
•
Default Route Advertisement—This option is defined globally in the
Properties
page. You can use the global definition or define this field for the specific
interface. The following options are available:
-
Global—Use the global settings defined in the RIPv2 Properties. screen.
-
Enable—Advertise the default route on this RIP interface.
-
Disable—On this RIP interface, do not advertise the default route.
•
Default Route Advertisement Metric—Enter the metric for the default route for this
interface.
•
Authentication Mode—RIP authentication state (enable/disable) on a specified IP
interface. The following options are available:
-
None—There is no authentication performed.
-
Text—The key password entered below is used for authentication.
-
MD5—The MD5 digest of the key chain selected below is used for authentication.
•
Key Password—If Text was selected as the authentication type, enter the password to
be used.
17
RIPv2
404
Hide quick links:
Advertisement
Table of Contents
