Cisco SX350 Series Administration Manual page 460

Managed switches
Hide thumbs Also See for SX350 Series:
Table of Contents

Advertisement

Security
Management Access Method
STEP 5
STEP 6
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
Enter the Access Profile Name. This name can contain up to 32 characters.
Enter the parameters.
Rule Priority—Enter the rule priority. When the packet is matched to a rule, user
groups are either granted or denied access to the device. The rule priority is essential to
matching packets to rules, as packets are matched on a first-match basis. The highest
priority is '1'.
Management Method—Select the management method for which the rule is defined.
The options are:
-
All—Assigns all management methods to the rule.
-
Telnet—Users requesting access to the device that meets the Telnet access profile
criteria are permitted or denied access.
-
Secure Telnet (SSH)—Users requesting access to the device that meets the SSH
access profile criteria, are permitted or denied access.
-
HTTP— Users requesting access to the device that meets the HTTP access profile
criteria, are permitted or denied.
-
Secure HTTP (HTTPS)—Users requesting access to the device that meets the
HTTPS access profile criteria, are permitted or denied.
-
SNMP—Users requesting access to the device that meets the SNMP access profile
criteria are permitted or denied.
Action—Select the action attached to the rule. The options are:
-
Permit—Permits access to the device if the user matches the settings in the profile.
-
Deny—Denies access to the device if the user matches the settings in the profile.
Applies to Interface—Select the interface attached to the rule. The options are:
-
All—Applies to all ports, VLANs, and LAGs.
-
User Defined—Applies to selected interface.
Interface—Enter the interface number if User Defined was selected.
Applies to Source IP Address—Select the type of source IP address to which the
access profile applies. The Source IP Address field is valid for a subnetwork. Select one
of the following values:
-
All—Applies to all types of IP addresses.
-
User Defined—Applies to only those types of IP addresses defined in the fields.
16
304

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents