Out-Of-Band Port - Cisco SX350 Series Administration Manual

1
!
CAUTION

Out-Of-Band Port

NOTE
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
• When the password expires, this page forces you to select a new password.
Logging Out
By default, the application logs out after ten minutes of inactivity. You can change this default
value as described in the
Unless the Running Configuration is copied to the Startup Configuration, rebooting the device
removes all changes made since the last time the file was saved. Save the Running
Configuration to the Startup Configuration before logging off to preserve any changes you
made during this session.
A flashing red X icon to the left of the Save application link indicates that Running
Configuration changes have not yet been saved to the Startup Configuration file. The flashing
can be disabled by clicking on the Disable Save Icon Blinking button on the Copy/Save
Configuration page
When the device auto-discovers a connected device, such as an IP phone (see
Smartport), and it configures the port appropriately for the device. These configuration
commands are written to the Running Configuration file. This causes the Save icon to begin
blinking when the you log on, even though you did not make any configuration changes.
When you click Save, the Copy/Save Configuration page appears. Save the Running
Configuration file by copying it to the Startup Configuration file. After this save, the red X icon
and the Save application link are no longer displayed.
To logout, click Logout in the top right corner of any page. The system logs out of the device.
When a timeout occurs or you intentionally log out of the system, a message is displayed and
the Login page appears, with a message indicating the logged-out state. After you log in, the
application returns to the initial page.
The initial page displayed depends on the "Do not show this page on startup" option in the
Getting Started page. If you did not select this option, the initial page is the Getting Started
page. If you did select this option, the initial page is the
OOB is only supported on SG350XG and SG550XG devices.
Defining Idle Session Timeout
Getting Started
Out-Of-Band Port
section.
What is a
System Summary page.
11