Toyota RAV4 PRIME 2021 Manual page 439

the button.
Programming an entry gate

(for U.S.A. owners)/Program-
ming a device in the Cana-
dian market
Press and release the remote
control transmitter button at 2
second intervals, repeatedly,
until the HomeLink
light changes from slowly flash-
ing orange to rapidly flashing
(green) (rolling code) or continu-
ously lit (green) (fixed code).
5
Test the HomeLink
tion by pressing the newly
programmed button and
observing the HomeLink
indicator light:
®
 HomeLink indicator light illu-
minates: Programming of a
fixed code device has com-
pleted. The garage door or
other device should operate
when a HomeLink
pressed and released.
®
 HomeLink indicator light
flashes rapidly: The garage
door opener or other device is
equipped with a rolling code.
To complete programming,
firmly press and hold the
®
HomeLink button for 2 sec-
onds then release it.
 If the garage door or other
device does not operate, pro-
ceed to "Programming a roll-
ing code system".
6-4. Using the other interior features
®
indicator
®
opera-
®
®
button is
6
Repeat the steps above to
program another device for
any of the remaining
®
HomeLink buttons.
Programming a rolling code
■
system
Two or more people may be
needed to complete rolling code
programming.
1
Locate the "Learn" or "Smart"
button on the garage door
opener motor in the garage.
This button can usually be found
where the hanging antenna wire is
attached to the unit. The name and
color of the button may vary by
manufacturer. Refer to the owner's
manual supplied with the garage
door opener motor for details.
2
Press and release the
"Learn" or "Smart" button.
3
Perform within 30 seconds after
performing 2.
439
6