Toyota RAV4 PRIME 2021 Manual page 342

342
5-5. Using the driving support systems
1
Accelerate with accelerator
pedal operation to the
desired vehicle speed
2
Press the "-SET" switch
Changing the vehicle-to-
vehicle distance (vehicle-
to-vehicle distance con-
trol mode)
Pressing the switch changes the
vehicle-to-vehicle distance as
follows:
1
Long
2
Medium
3
Short
The vehicle-to-vehicle distance is
set automatically to long mode
when the power switch is turned to
ON.
If a vehicle is running ahead of you,
the preceding vehicle mark
also be displayed.
Vehicle-to-vehicle dis-
tance settings (vehicle-to-
vehicle distance control
mode)
Select a distance from the table
below. Note that the distances
shown correspond to a vehicle
speed of 50 mph (80 km/h).
Vehicle-to-vehicle distance
increases/decreases in accor-
dance with vehicle speed. When
the vehicle is stopped by system
control, the vehicle stops at a
certain vehicle-to-vehicle dis-
tance depending on the situa-
tion.
Distance options
Medium
Resuming follow-up
cruising when the vehicle
has been stopped by sys-
tem control (vehicle-to-
vehicle distance control
mode)
After the vehicle ahead of you
starts off, press the "+RES"
switch.
will
A
Your vehicle will also resume
follow-up cruising if the acceler-
ator pedal is depressed after the
vehicle ahead of you starts off.
Vehicle-to-vehi-
cle distance
Approximately
Long
160 ft. (50 m)
Approximately
130 ft. (40 m)
Approximately
Short
100 ft. (30 m)