Using The Solo Bus For; Monitoring - PRESONUS StudioLive III Series Owner's Manual

10 Monitoring Controls
10.1 Solo Controls
Using the Solo Bus for Monitoring
10.1.2
Talk Prev Next
AUX
Select Select Select Select Select
Inputs
DCA
Solo Solo Solo
GEQ
Groups
Mix/FX
Mute Mute Mute Mute Mute
Master
Talk
Prev Next
AUX
Select Select Select
Select
Inputs
DCA
Solo Solo Solo
GEQ
Groups
Mix/FX
Master
Monitor Edit Phones
Delay
Main Solo
Tape
0.0 ms
Mix 1 Mix 2 Mix 3 Mix 4 Mix 5 Mix 6 Mix 7
Solo
Mix 9 Mix 10 Mix 11 Mix 12 Mix 13 Mix 14 Mix 15
Mix 7
Mix 17 Mix 18 Mix 19 Mix 20 Mix 21 Mix 22 Mix 23
Mix 10 Mix 11
Mix 25 Mix 26 Mix 27 Mix 28 Mix 29 Mix 30 Mix 31
Mix 14 Mix 15
Prev Next
Inputs Select Select
User Solo Solo
Mute Mute
Main
Mix
1 17 2 18
3 19 4 20
5 21 6 22
7 23 8 24
9 25 10 26
When mixing live, or when recording multiple musicians at once, it is often necessary
to quickly listen to just one instrument or group. The Solo and Monitor buses can be
used together for this purpose. It is important to note that if you wish to monitor with
speakers, rather than with headphones, it is necessary to connect the speakers to the
Monitor Outs, rather than to the Main Outputs.
To use the Solo bus for monitoring purposes, do the following:
1. Press the Edit button in the Solo section to bring up the Solo screen.
Enable the Pre-Fader Listen option if you want to hear the soloed channels
2.
Select Select
pre-fader (unaffected by fader level). Disable it if you want channel levels to
Solo Solo
be affected by fader levels.
Mute Mute
3. Touch Latch in the Solo Mode section of the Touch Display to enable the
Latch solo mode. This lets you solo multiple channels at the same time,
which is usually desired, in this case.
4. Press the Edit button in the Monitors section to bring up the Monitor
screen.
5. Press Monitors if you want to listen on your booth or control room
Select Select
Solo Solo
speakers. Press Phones if you want to listen on headphones. This brings up a
list of available sources to route to the chosen monitoring system.
6. Touch Solo on the Touch Display to route the Solo bus to the monitor
Monitor
system you've chosen.
Mix 8
Mix 16
Mix 24
Mix 32
Press Solo on the channels or buses you want to monitor. The signal being
7.
fed to the Main outputs is unaffected.
Select Select
Solo Solo
Mute Mute
StudioLive™ Series III
Owner's Manual
100