Assigning Geqs; Using The Geq - PRESONUS StudioLive III Series Owner's Manual

11 Graphic EQ
11.1

Assigning GEQs

Assigning GEQs
11.1
11.2

Using the GEQ

To assign a Graphic EQ to one of the mixes, select the desired mix and press the GEQ
button. This will open the GEQ screen. Touching a mix will insert a Graphic EQ on it
post-fader.
On the upper right hand side of the screen, you will see how many GEQs are available
to be assigned.
You will be alerted when every available GEQ has been assigned.
Once assigned, you can access the GEQ at any time by pressing the GEQ button on
your desired mix:
Use the Fat Channel encoders to control the Graphic EQ in banks of eight. Use the
Master Control encoder to scroll to a different bank.
1 2 3 4 5
1. On/Off. Use this button to enable/disable the current GEQ.
2. Current Bank. By default, the GEQ is controlled from the Fat Channel encoders
in banks of eight. This highlights the bank that is currently being controlled from
the Fat Channel. Use the value encoder to move to another bank.
3. Assign. Opens the Assign GEQ screen. See Section 11.1.
4. Reset. Press this button to flatten the GEQ.
5. To Faders. Enable this button to control your GEQ from your StudioLive faders.
6. RTA. Enables the RTA. See Section 11.4.
StudioLive 32SX and 32SC Users Power User Tip: For StudioLive 32SX and 32SC users,
the RTA can be enabled and disabled from the control surface by pressing the RTA button.
7. Pre/Post-GEQ. Enables Pre- or Post-GEQ viewing on the RTA. See Section 11.4.
8. Presets. Opens the GEQ Presets screen. See Section 11.3.
6 7 8
StudioLive™ Series III
Owner's Manual
103