Output Assignment Buttons; Main/Mono Bus Assignment - PRESONUS StudioLive III Series Owner's Manual

6 The Fat Channel
6.11

Output Assignment Buttons

Output Assignment Buttons
6.11
6.11.1 Main/Mono Bus Assignment (StudioLive 64S only)
6.11.2 Main/Subgroup Assignment (All 32-Channel StudioLive Models)
To assign a channel to multiple FlexMix Subgroups:
Level
Page
OL
-2
Processor
(Insert)
-12
-24
Channel
-36
-48
-65
Input Mic/Line Assign Stereo
When an input channel is selected, you can use these buttons to assign it to the Main
and Mono/Center buses. Press L/R to send the selected channel output to the Main
Stereo bus. Press Mono/Center to send the channel output to a Mono or Center bus
(Pan Mode dependent).
For more information on the Main bus, see Section 5.6.
When an input channel is selected, you can use these buttons to assign it to an
output path. Press Main to send the selected channel output to the Main bus. Press
SubGrp to open the Bus Assignment screen on the Touch display.
You can assign a channel output to a subgroup in two different ways:
Press the Subgroup button and release it, the Subgroup Assignment view shows
in the Touch Display, with a list of all available subgroups. You can then touch the
desired subgroup to route the channel to the subgroup of your choice.
Comp
While the channel is selected, press and hold the SubGrp button in the
EQ / Dyn 1.
Assign section of the Fat Channel.
Preset
2. The available subgroup FlexMix select buttons will flash. Press the FlexMix
select buttons for the subgroups to which you'd like to assign the channel.
StudioLive™ Series III
Owner's Manual
72