Solo Bus - PRESONUS StudioLive24.4.2 Owner's Manual

Owner's Manual
FireWire Source On/Off
Button

4.7.4 Solo Bus

Cue Mix Volume Control
PFL/AFL Toggle Button
SIP (Solo In Place)
On/Off Button
Sends the Master Out from the Audio Application to the Mains.
This button routes the main left/right FireWire returns (Outputs 25 and 26) to the
main outputs. It will illuminate to indicate that the main FireWire return is being
sent to the main outputs of the StudioLive. To disable the routing, simply press the
button again. For more information on using the main FireWire returns, please
consult Sections 6.4.2, 6.4.4, and 6.4.5.
The StudioLive features a Solo bus for flexible monitoring. In this
way, you can fine-tune a vocal compressor in your control-room
monitors or headphones while the rest of the band is warming up
or audition an aux mix for more accurate adjustments. For more
information on using the Solo bus, please review Section 8.8.
Adjusts the Overall Volume of the Solo Bus.
This knob adjusts the overall level for the Solo bus.
.
Enables PFL Solo Mode.
The default setting for the Solo bus is After-Fader Listen (AFL); by pressing PFL,
Pre-Fader Listening is enabled. In either mode, pressing Solo on any channel or bus
routes that channel to the Solo bus and has no effect on the main or subgroup
mixes. PFL soloing is not available for the Subgroups. The Aux bus soloing is always
PFL, regardless of whether this mode is enaged.
Enables Solo In Place Mode.
SIP (Solo In Place), or "destructive soloing, " mutes every unsoloed channel on the
StudioLive. If one of the muted channels is routed to the mains or a subgroup, it
will be muted in those outputs. This also applies to soloed channels: The output
routing is still active. Note that while you can manually unmute a channel, this
mode should be used with extreme caution during a live performance. Only the
input channels can be placed into destructive soloing. The Subgroups and Aux
buses are omitted from SIP mode.
To enable SIP, press and hold the button until it illuminates red. This
ensures that you cannot enter into destructive Solo mode by accident.
When SIP is engaged, channel mutes will only apply to the Subgroup and
Main assignments. SIP does not mute input channels in Aux Send mixes.
Controls 4
Master Section 4.7
47 47